H3C S3600V2 SERIES, Layer 2-Lan Switching Configuration Manual

Page: 267 / 281

252
Step Command Remarks
3. Configure the MVRP
registration mode.
mvrp registration { fixed |
forbidden | normal }
Optional.
The default setting is normal
registration mode.
Configuring MRP timers
CAUTION:
The MRP timers apply to all MRP applications, for example, MVRP, on a port. To avoid frequent VLAN
registrations and deregistrations, use the same MRP timers throughout the network.
Each port maintains its own Periodic, Join, and LeaveAll timers, and each attribute of a port maintains a
Leave timer.
To configure MRP timers:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
•
Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
Use one of the commands.
3. Configure the LeaveAll timer.
mrp timer leaveall timer-value
Optional.
The default setting is 1000
centiseconds.
4. Configure the Join timer.
mrp timer join timer-value
Optional.
The default setting is 20
centiseconds.
5. Configure the Leave timer.
mrp timer leave timer-value
Optional.
The default setting is 60
centiseconds.
6. Configure the Periodic timer.
mrp timer periodic timer-value
Optional.
The default setting is 100
centiseconds.
Table 28 shows the value ranges for Join, Leave, and LeaveAll timers and their dependencies.
• If you set a timer to a value beyond the allowed value range, your configuration will fail. To do that,
you can change the allowed value range by tuning the value of another related timer.
•
To restore the default settings of the timers, restore the Join timer first, followed by the Leave and
LeaveAll timers.