253
Table 28
Dependencies of the Join, Leave, and LeaveAll timers
Timer Lower
limit
Upper limit
Join
20 centiseconds
Half the Leave timer
Leave
Twice the Join timer
LeaveAll timer
LeaveAll
Leave timer on each port
32760 centiseconds
NOTE:
You can restore the Periodic timer to the default at any time.
Enabling GVRP compatibility
MVRP can be compatible with GVRP. When the peer device supports GVRP, you can enable GVRP
compatibility on the local end, so that the local end can receive and send MVRP and GVRP protocol
packets at the same time.
Configuration restrictions and guidelines
•
MVRP with GVRP compatibility enabled can work together with STP or RSTP, but cannot work
together with MSTP. When MVRP with GVRP compatibility enabled works with MSTP, the network
might operate improperly.
•
When GVRP compatibility is enabled for MVRP, H3C recommends disabling the Period timer.
Otherwise, the VLAN status might frequently change when the system is busy.
Configuration procedure
To enable GVRP compatibility:
Step Command
Remarks
1.
Enter system view
system-view
N/A
2.
Enable GVRP
compatibility
mvrp gvrp-compliance
enable
By default, GVRP compatibility is disabled.
Displaying and maintaining MVRP
Task Command
Remarks
Display the MVRP status of
the specified port and each
MVRP interface in the
specified VLAN.
display mvrp state interface
interface-type
interface-number
vlan
vlan-id
[ | {
begin
|
exclude
|
include
}
regular-expression
]
Available in any view
Display the MVRP running
status.
display mvrp running-status
[
interface
interface-list
] [ | {
begin
|
exclude
|
include
}
regular-expression
]
Available in any view
