Installation Manual
H3C S3100-52P Ethernet Switch
Chapter 3 Installing the Switch
3-2
(1)
(2)
L2
r
L1
(1): Screw hole used to fix the mounting ear to the cabinet (Use one M6 screw)
(2): Screw hole used to fix the switch to the mounting ear
Figure 3-1
Appearance of a standard front mounting ea
Note:
If you install a S3100-52P switch into a 19-inch standard cabinet, the configuration type
of the front mounting ear is standard configuration.
II. Use front mounting ears to install a switch
Follow these steps to mount a switch into a 19-inch standard cabinet:
1) Wear an ESD-preventive wrist strap to check the grounding and stability of the
cabinet.
2) Take out the screws which are packed together with the front mounting ears, and
fix one end of mounting ears to the switch, as shown in Figure 3-2.
Front panel
)
Figure 3-2
Fix front mounting ears (1
