2-12
1.
Verify that the workbench is sturdy and reliably grounded.
2.
Place the switch with bottom up, and clean the round holes in the chassis bottom with dry cloth.
3.
Attach the rubber feet to the four round holes in the chassis bottom.
4.
Place the switch with upside up on the workbench.
Mounting the switch on a wall
CAUTION:
•
Before drilling holes in a wall, make sure no electrical lines exist in the wall.
•
Leave a minimum clearance of 10 cm (3.94 in) around the chassis for heat dissipation.
describes the switch models that support wall mounting and installation holes distances
required for wall-mounting the switch.
Table2-3 Installation hole distances for switch models that support wall mounting
Switch model
Hole distance
S1850V2-9P-EI
S1850V2-10P-EI
170 mm (6.69 in)
S1850V2-10P-PWR-EI
S1850V2-10P-HPWR-EI
102 mm (4.02 in)
Use the provided screw anchors and screws with a length of 20 mm (0.79 in) to wall-mount the
switch.
Figure2-8 Screw anchor and screw
To mount the switch on a wall:
1.
Mark two installation holes on the wall. Make sure the two holes are on the same horizontal line.
See
for the distance requirement between the two holes.
Figure2-9 Installing the switch on a wall (1)
20 mm (0.79 in)
