21
Figure 16 Installing a fan tray for the S12504X-AF switch
(1) Align the positioning pin on the fan tray with the positioning hole above the fan tray slot
(2) Insert the fan tray into the chassis
(3) Fasten the captive screws on the fan tray
Installing fan trays for an S12502X-AF switch
CAUTION:
To install a fan tray in slot FAN1, orient the fan tray so that the LED is on the left side of the front
panel. To install a fan tray in slot FAN2, orient the fan tray so that the LED is on the right side of the
front panel.
The following procedure uses slot FAN1 as an example.
To install a fan tray in slot FAN1 for the switch:
1.
As shown by callouts 1 and 2 in
, remove the screws on the filler panel with a Phillips
screwdriver. Supporting the bottom of the filler panel with one hand, use your thumb and
forefinger of the other hand to hold the filler panel through the two holes and pull out the filler
panel along the guide rails.
Keep the removed filler panel secure for future use.
2.
Unpack the fan tray.
3.
Orient the fan tray correctly.
4.
Holding the fan tray handle with one hand and supporting the bottom of the fan tray with the
other, steadily insert the fan tray part way into the slot. See callout 3 in
.
Keep the fan tray as steady as possible while inserting it into the slot.
5.
Squeezing the captive screw at the air vents side with one hand and holding the fan tray handle
with the other, push the fan tray fully into the slot.
6.
Fasten the captive screws on the fan tray. See callout 4 in