14
3.
As shown by callout 3 in
, pull the ejector levers of the MPU outward when most part
of the MPU is inserted in the slot.
4.
Push the MPU until the brakes on its ejector levers touch the slot edges tightly.
5.
As shown by callout 4 in
, continue to push the MPU by its middle part on the front
panel until you cannot move it.
6.
As shown by callout 5 in
, push the ejector levers inward until they come in close
contact with the front panel.
7.
As shown by callout 6 in
, fasten the captive screws on the MPU.
Figure 13 Installing an MPU (S12516X-AF switch)
(1) Loosen the captive screws and remove the filler panel
(2) Insert the MPU into the slot
(3) Pull the ejector levers outward
(4) Push the MPU by the middle part on the front panel
(5) Pull the ejector levers inward
(6) Fasten the captive screws
Installing MPUs for the S12504X-AF switch
The S12504X-AF switch MPU marks and MPU slot edges are pink-marked.
To install an MPU for the S12504X-AF switch:
1.
As shown by callout 1 in
, remove the filler panel from the target MPU slot.
Keep the removed filler panel secure for future use.
2.
As shown by callout 2 in
, pivot up the handle of the MPU.
3.
As shown by callout 3 in
, orient the MPU with lettering on it upright. Hold the MPU by
the front panel with one hand and support the bottom with the other. Push the MPU steadily
into the slot along the guide rails.
Keep the MPU parallel to the slot to avoid touching other components in the chassis.
1
2
3
3
4
5
5
6
