8
•
To allow the local user to Telnet to the switch, authorize the local user to use the Telnet service.
•
To allow the local user to use all commands, assign the user role network-admin to the local user.
The user role of a login user depends on the user role setting for the local user. It is
network-operator by default when local scheme authentication is used.
Software version used
This configuration example was created and verified on S12500-CMW710-R7129.
Configuration procedures
# Enable Telnet server.
<switch1> system-view
[switch1] telnet server enable
# Configure interface GigabitEthernet 7/0/35.
[switch1] interface Vlan-interface 5
[switch1-Vlan-interface5] ip address 15.15.1.1 16
[switch1-Vlan-interface5] quit
[switch1] interface GigabitEthernet 7/0/35
[switch1-GigabitEthernet7/0/35] port link-mode bridge
[switch1-GigabitEthernet7/0/35] port access vlan 5
[switch1-GigabitEthernet7/0/35] quit
# Enable scheme authentication for all VTY user interfaces.
[switch1] user-interface vty 0 15
[Switch1-ui-vty0-15] authentication-mode scheme
[Switch1-ui-vty0-15] quit
# Configure a local user with the username
test
and password
test
.
[Switch1] local-user test class manage
[Switch1-luser-manage-test] password simple test
# Assign the user role network-admin and the Telnet service to the user.
[Switch1-luser-manage-test] authorization-attribute user-role network-admin
[Switch1-luser-manage-test] service-type telnet
[Switch1-luser-manage-test] quit
Verifying the configuration
# Telnet to the switch. Verify that the system displays a prompt for the username and password.
******************************************************************************
* Copyright (c) 2004-2013 Hewlett-Packard Development Company, L.P. *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
******************************************************************************
login: test
Password: