H3C MSR810, Command Reference Manual

Page: 41 / 389

29
ppp timer negotiate
Use
ppp timer negotiate
to set the PPP negotiation timeout time on an interface.
Use
undo ppp timer negotiate
to restore the default.
Syntax
ppp timer negotiate seconds
undo ppp timer negotiate
Default
The PPP negotiation timeout time is 3 seconds on an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
seconds
: Specifies the negotiation timeout time in the range of 1 to 10 seconds.
Usage guidelines
In PPP negotiation, if the local device receives no response from the peer during the timeout time
after it sends a packet, the local device sends the last packet again.
Examples
# Set the PPP negotiation timeout time to 5 seconds on Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] ppp timer negotiate 5
remote address
Use
remote address
to configure an interface to assign an IP address to the client.
Use
undo remote address
to restore the default.
Syntax
remote address
{
ip-address
|
pool pool-name
}
undo remote address
Default
An interface does not assign an IP address to the client.
Views
Interface view
Predefined user roles
network-admin
Parameters
ip-address
: Specifies the IP address to be assigned to the client.
pool pool-name
: Specifies a PPP or DHCP address pool by its name from which an IP address is
assigned to the client. The pool name is a case-sensitive string of 1 to 31 characters.