H3C MSR810, Command Reference Manual

Page: 307 / 389

295
dialer timer autodial
dialer peer-name
Use
dialer peer-name
to specify the host name of the remote device for authenticating incoming
calls.
Use
undo dialer peer-name
to remove the specified host name.
Syntax
dialer peer-name username
undo dialer peer-name
[
username
]
Default
No host name of the remote device is specified for authenticating incoming calls.
Views
Dialer interface view
Predefined user roles
network-admin
Parameters
username
: Specifies the host name of the remote device, a case-insensitive string of 1 to 80
characters.
Usage guidelines
The local device matches the peer names obtained in PPP authentication with the host names
configured by this command to determine which dialer interface receives which call.
This command takes effect only on bundle DDR dialer interfaces. You can configure a maximum
number of 255 host names for a dialer interface. This enables one dialer interface to receive calls
from multiple physical interfaces.
If a bundle DDR dialer interface is not configured with any host name, this interface can place calls
but cannot receive calls.
Examples
# Specify the host name of the remote device for Dialer 1 to
routerb
.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] dialer peer-name routerb
dialer priority
Use
dialer priority
to assign a priority to a physical interface in a dialer circular group.
Use
undo dialer priority
to restore the default.
Syntax
dialer priority priority
undo dialer priority
Default
The priority of a physical interface in a dialer circular group is 1.