76
undo stp no-agreement-check
Default
No Agreement Check is disabled.
Views
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default command level
2: System level
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware
Command compatibility in Layer 2
aggregate interface view
MSR800 Yes
MSR 900
No
MSR900-E Yes
MSR 930
Yes
MSR 20-1X
No
MSR 20
No
MSR 30
Yes
MSR 50
Yes
MSR 2600
Yes
MSR3600-51F Yes
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in port group view, the setting takes effect on all member ports in the port group.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate
interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port
leaves the aggregation group.
This feature takes effect only after you enable it on the root port.
Examples
# Enable No Agreement Check on Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] stp no-agreement-check
stp pathcost-standard
Use
stp pathcost-standard
to specify a standard for the device to use when calculating the default
path costs for ports.
Use
undo stp pathcost-standard
to restore the default.
