4
Table 4 QSFP+ port LED description
LED status
Description
Steady green
A transceiver module is installed in the port. The
port is operating at 40 Gbps, and a link is
present on the port.
Flashing green
The port is sending or receiving data at 40 Gbps.
Off
No transceiver module is installed in the port, or
no link is present on the port.
▌
Installing and removing the card
CAUTION:
•
Before you install or remove the card, wear an ESD wrist strap
and make sure the strap makes good skin contact and is
reliably grounded.
•
To avoid device damage, do not use excessive force when you
install or remove the card.
•
The LSWM116Q interface card is hot swappable. However, do
not install or remove it during the startup of the switch.
Installing the card
1.
Remove the filler panel (if any) from the target slot.
Keep the removed filler panel secure for future use.
2.
Unpack the interface card.
Figure 2 LSWM116Q interface card
(1) Ejector lever
(2) Latch
