H3C LSQM1QGS8A0, User Manual

Page: 6 / 7

6
2.
Press the latch on the interface card to release the ejector lever.
3.
As shown by callout 1 in Figure 3 , insert the interface card slowly
into the slot along the guide rails.
4.
Rotate inward the ejector lever as shown by callout 2 in Figure 3
until the latch locks the ejector lever in place.
Figure 3 Installing an LSQM1QGS8A0 interface card
Removing an interface card
CAUTION:
•
Before you remove an interface card, remove the cable from it
to avoid cable damage.
•
After removing an interface card, if no new interface card is to
be installed, install the filler panel as soon as possible to
prevent dust and ensure good ventilation in the device.
To remove an interface card:
1.
Prepare an anti-static bag.
2.
Press the latch to release the ejector lever
3.
Rotate outward the ejector lever as shown by callout 1 in Figure 4 .
4.
Pull out the interface card slowly out of the interface card slot, as
shown by callout 2 in
Figure 4 .
5.
Place the removed interface card in the anti-static bag.
1
2