Routing
H3C Low-End Ethernet Switches Configuration Examples
Chapter 1 Routing Overview
1-6
VII. Configuring RIP to filter incoming/outgoing routes
Table 1-11
Configure RIP to filter incoming/outgoing routes
Operation
Command
Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
filter-policy
{
acl-number
|
ip-prefix ip-prefix-name
[
gateway
ip-prefix-name
] |
route-policy
route-policy-name
}
import
Configure RIP to
filter incoming routes
filter-policy gateway
ip-prefix-name import
Required
By default, RIP does not
filter any incoming route.
The
gateway
keyword is
used to filter the incoming
routes advertised from a
specified address.
filter-policy
{
acl-number
|
ip-prefix ip-prefix-name
}
export
[
protocol
] [
process-id
]
Configure RIP to
filter outgoing routes
filter-policy
route-policy
route-policy-name
export
Required
By default, RIP does not
filter any outgoing route.
VIII. Setting RIP preference
Table 1-12
Set RIP preference
Operation
Command
Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Set the RIP preference
preference
value
Required
The default RIP preference is 100.
IX. Enabling load sharing among RIP interfaces
Table 1-13
Enable load sharing among RIP interfaces
Operation
Command
Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Enable load sharing
among RIP interfaces
traffic-share-across-inte
rface
Required
By default, load sharing
among RIP interfaces is
disabled
