H3C ICG2000, Installation Manual

Page: 24 / 29

2-12
Starting the device
WARNING!
Before powering on the device, locate the switch for the power source so that you can cut off
power promptly in case of an emergency.
NOTE:
To access the device when it starts up with the factory-default configuration, you must press
CTRL+D .
To start the device:
1. Verify the installation and the configuration environment is as described in " Verifying the
installation ."
2. Power on the device.
3. During the booting process, verify the following items:

The LEDs on the front panel are in the states as described in Table2-2 .
Table2-2 LED states when the device is operating correctly
LED State Description
PWR Steady green The power system is operating correctly.
SYS Slowly flashing green The device system is operating correctly.

The configuration terminal displays information correctly.
The device first initializes its memory at startup. Then it runs BootWare.
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU...
Booting Normal Extended BootWare
The Extended BootWare is self-decompressing....Done.
****************************************************************************
* *
* H3C ICG2000D BootWare, Version 1.02 *
* *
****************************************************************************
Copyright (c) 2004-2017 New H3C Technologies Co., Ltd.
Compiled Date : Sep 18 2017
CPU ID : 0xc
CPU L1 Cache : 32KB
CPU L2 Cache : 1024KB
Memory Type : DDR3 SDRAM
Memory Size : 1024MB
Flash Size : 256MB
CPLD Version : 131.0
PCB Version : 2.0