H3C H3C S7500E Series, Installation, Quick Start, Page: 2 / 4

4
Installing cable management brackets
安装走线架
Attaching cable management brackets to the
S7506E-V switch
安装
S7506E-V
机型的走线架
Installing the switch in a rack
安装交换机到机柜
After placing the switch on the slide rails, do not leave go of your hands immediately because this
might tip the switch. Tipping the switch might cause switch damage and even bodily injury.
将机箱放至滑道后，请确保机箱放置平稳后再松手，以免机箱倾倒而损坏设备，甚至伤害您的身体。
!
Installing mounting brackets
安装挂耳
Grounding the switch
交换机接地
1
2
3
1
2
2
1
1
2
2
1. Place the cable management bracket against the chassis
and align the screws with the screw holes in the chassis.
2. Use a screwdriver to fasten the screws.
1.
将走线架紧贴机箱，同时将螺钉对准机箱上对应的螺钉孔。
2.
用螺丝刀沿顺时针方向拧紧螺钉，固定住走线架。
Attach the cable management bracket
to the left mounting bracket, which has
installation holes for the cable
management bracket.
将走线架安装到带有走线架安装螺孔的
左挂耳上。
Attaching the cable management bracket to
S7500E switch models except S7506E-V
安装
S7500E
系列其他机型的走线架
Use a minimum of two people to move the switch. For heavy models, use a mechanical lift as a best
practice.
要求多人配合（不少于2人）搬运设备，对于较重机型， 推荐您使用机械设备搬运。
3
To ensure the grounding effect, use the
yellow-green grounding cable provided with
the switch to ground the switch.
为了保证良好的接地效果，请使用随机附带
的接地线（黄绿双色保护接地电缆）。
Connect the grounding cable to the grounding
system in the equipment room. Do not
connect it to a fire main or lightning rod.
消防水管和建筑物的避雷针接地都不是正确的
接地位置，交换机的接地线应该连接到机房的
工程接地。
Do not try to move the chassis by holding an FRU handle, air vents of chassis, or the handle on the
rear. Any attempt to carry the switch with these parts might cause equipment damage or even bodily
injury.
请勿试图通过抓握设备模块（风扇框、电源）把手、机箱通风孔或机箱后面板拉手来进行设备的搬运，
否则可能因该部件无法承重而引起设备损坏，甚至会伤害到您的身体。
!
1
2
2
2
2
2
2
2
2
1
!
Installing FRUs
安装模块
Before installing a card in the
chassis, make sure the connectors
on the card are not broken or
blocked.
安装前，请检查单板的连接器是否
有破损和堵塞，以免对机箱背板造
成损坏。
!
Installing cards
安装单板
2
1
3
4