2-18
Table2-5 Installation hole distances for switch models that support wall mounting
Switch model
Hole distance
FS5100-8S-PWR-EI
FS5100-12S-EI
FS5100-12MS-EI
FS5100-12S-PWR-EI
FS5100-12MS-PWR-EI
FS5100-20MS-EI
FS5100-20MS-PWR-EI
170 mm (6.69 in)
17 mm (0.67 in) long screws and screw anchors as shown in
switches for wall-mounting.
Figure2-13 Screw anchor and screw
To mount the switch on a wall:
1.
Mark two installation holes on the wall. Make sure the two holes are on the same horizontal line.
See
for the distance requirement between the two holes.
Figure2-14 Installing the switch on a wall (1)
2.
Drill two holes with a diameter of 6 mm (0.24 in) and a depth of 25 mm (0.98 in) at the marked
locations. Hammer the screw anchors into the wall and use a Phillips screwdriver to fasten the
screw into the screw anchor. Leave 1.5 mm (0.06 in) between the screw head and the wall for
hanging the switch.
