12-2
Repacking the FRUs
Repacking power supplies
CAUTION:
To avoid device damage and bodily injury, switch off the circuit breakers at the input ends of all
power cords and remove all the power cords before removing power supplies.
To repack a power supply:
1.
Prepare the original packing materials, including the anti-static bag, foam cushion, and packing
box for a power supply. Make sure these packing materials are clean, dry, and not damaged.
2.
Remove the power supply from the chassis.
For the power supply removal procedure, see "Replacement procedures."
3.
Put the removed power supply into the anti-static bag.
4.
Place the foam cushion over the power supply.
5.
Place the power supply and the foam cushion in the packing box, and seal the box with tape.
6.
Perform the same steps to repack the other power supplies.
Repacking the modules
1.
Prepare the original packing materials, including the anti-static shielding bag, foam cushion,
and packing box, for a module. Make sure these packing materials are clean, dry, and not
damaged.
2.
Remove the transceiver modules from the modules.
If no transceiver module is installed, skip this step.
For information about how to remove a transceiver module, see "Replacement procedures."
3.
Remove a module from the chassis.
If a filler panel is provided for the module slot, install the filler panel in the slot after you remove
the chassis from the rack.
For information about how to remove a module and install a filler panel, see "Replacement
procedures."
4.
Put the removed module into an anti-static bag.
For a module provided with a metal protection box, install the metal protection box for it before
putting it into an anti-static bag.
5.
Place the foam cushion over the module.
6.
Put the module and the foam cushion into the box, and seal the box with tape.
7.
Perform the same steps to repack the other modules.
Repacking the fabric module slot filler panels
1.
Prepare the original packing materials, including the packing bag, foam cushion, and packing
box, for a fabric module slot filler panel. Make sure these packing materials are clean, dry, and
not damaged.
2.
Remove the fabric module slot filler panel.
3.
Place the removed fabric module slot filler panel in the packing bag.
4.
Place the foam cushion over the packing bag.
