H3C CR19000-20, Installation Manual

Page: 67 / 139

4-8
The number of screws for securing the protection box in Figure4-7 is for illustration only and the
actual number of screws on your interface module might differ from that.
Figure4-7 Removing the protection box
4. Correctly orient the interface module. Align the module with the slot and push it steadily into the
slot along the guide rails until about half of the module is in the slot.
Figure4-8 Installing an interface module that uses detachable ejector levers
5. Attach the ejector lever holders to the chassis or cabinet and then remove the ejector levers
from the holders.
6. Identify the L and R marks on the ejector levers and attach them to left and right ejector lever
retainers of the interface module, with the lettering on the ejector levers facing upward.