H3C CR16000-M, Installation Manual, Page: 81 / 116

5
FigureA-6 Affixing a label
Bind cable ties on both ends of a cable. After the bundling, the finished identification plate should be
on top of the cable in horizontal cabling, or on the right side of the cable in vertical cabling. Make sure
the label is facing out, as shown in
FigureA-7 .
FigureA-7 Affixed labels
Affixing a generic label
The requirements for affixing a generic label are the same as affixing a label on a signal cable. For
more information, see "
Affixing a label to a signal cable ." For the example of affixed labels, see
FigureA-8 .
TO:
B03 -48V2
TO :
B0 3
–
4 8 V 2
TO
:
B
03
–
48
V
2