4
Mounting the antenna
You can mount the ANT-5014P-M4 antenna on a pole. The installation accessories are provided
(installation tools are user supplied). If you intend to install your antenna in a way other than what is
described in this document, you must provide the appropriate installation accessories.
Installation accessories and tools
•
Installation accessories provided with the antenna:
One L-mounting bracket.
Two U-bolts.
Two pole-mount clamps.
Eight M6 nuts.
Eight flat washers with an inner diameter of 6 mm (0.24 in).
Eight spring washers with an inner diameter of 6 mm (0.24 in).
•
User-supplied installation tools:
One adjustable wrench.
One pole with a diameter of 30 to 50 mm (1.18 to 1.97 in).
Mounting the antenna on a pole
1.
Use four M6 nuts, four flat washers, and four spring washers to attach the L-mounting bracket to
the antenna. (See callout 6 in
2.
Place a U-bolt around the pole, and pass the U-bolt through the target installation holes on a
pole-mount clamp.
3.
Place a spring washer and flat washer on each end of the U-bolt, start an M6 nut on each end of
the U-bolt, and then fasten the nuts.
4.
and
to attach the other U-bolt to the other pole-mount clamp.
5.
To change the vertical orientation of the antenna, select different installation holes in the
L-mounting bracket as needed.
