Manual Version:5PW100-20120627
5
Mounting the antenna on a ceiling
1.
Drill an 18 mm (0.71 in) diameter hole in the ceiling where you want to mount the antenna. See
callout 1 in
.
2.
Remove the flat washer (callout 5 in
) from the antenna.
3.
Thread the antenna connector and cable through the hole you drilled in step 1 until the base of the
antenna is flush with the ceiling.
4.
From above the ceiling, thread the antenna connector and cable through the opening on the split
flat washer.
5.
Thread the split flat washer through the antenna’s thread and fasten it until the antenna is secured
in place.
Figure 6
Mounting the antenna to the ceiling
(1) Mounting hole
(2) Ceiling
(3) Antenna connector
(4) Cable
(5) Split flat washer
(6) Antenna thread
Recommended cable
H3C recommends that you use a high-quality, low-loss cable with the antenna. Coaxial cable loses
efficiency as the frequency increases, causing signal loss. Keep the cable as short as possible because
cable length also causes signal loss (the longer the run, the greater the loss).
1
2
3
4
5
6
