APPLIANCE OPERATION
Take the appliance mains electricity lead on the rear of the Ice Maker and insert the plug into a suitable mains
electricity supply. The Ice Maker should be positioned for easy access to the mains lead and plug to facilitate rapid
electrical isolation when required. The medium ice cube size green light will be
fl
ashing.
Press the START button and hold down for two seconds before releasing. The green medium cube size light will illuminate
permanently indicating the unit is operating. It may take up to three minutes for the ice making cycle to start because
internal components and timers may need to reset themselves. After the unit has been running for a few minutes the
water temperature will start getting lower, as the
fl
owing water temp reaches 0 degrees the selected size light (S, M, L) will
start to
fl
ash as the ice cubes are now starting to form. Once completely formed the size indicator will
fl
ash faster until the
defrost cycle starts and the cubes are harvested.
It is suggested that the medium size cube setting is maintained and if the cubes are of acceptable size, after three or
four cycles, them the size should be left on medium. If larger or smaller cubes are required then press the cube selector
button until the required size is illuminated. Changes to cube size can be made at any time but consistent cube size
may take several cycles.
After approximately 18 minutes the
fi
rst lot of 36 ice cubes will be deposited into the Ice Cube Basket, Precise timings for
each cycle are not possible because the unit includes automatic temperature compensation that increases the cycle
time for cooler ambient conditions and colder water.
The approximate timings for small and large cube sizes are 10 to 14 minutes and 18 to 22 minutes respectively.
When the Ice Cube Basket is full the appliance will detect this and the Ice Cube Basket Full Warning light will
illuminate red. The basket should be taken out and emptied of cubes and replaced or it can be left in place and emptied
using the Ice Scoop. If the Ice Cube Basket is not emptied the unit will go into sleep mode. Once ice cubes have been
removed the ice making process will re-start again automatically. If ice cubes are not removed they will eventually melt
and once suf
fi
cient cubes have melted to clear the sensors the unit will re-start automatically.
4.
