Prior to use verify:
1.
The O-ring is lightly lubricated and seated within the track in the lid.
2.
The O-ring and contact surface are free of scratches and other imperfections.
Do NOT use if:
1.
The O-ring is dry, cracked, twisted, and/or out of alignment.
2.
O-ring and/or contact surfaces have any dirt, lint, hair, and/or other debris.
3.
The O-ring and contact surface have scratches and other imperfections.
Replacement
H2O Audio has provided an extra O-ring. The O-ring should be replaced annually or in the event of damage,
loss, overexposure to direct sunlight, or become misshaped through misuse. To replace the O-ring:
1.
Remove the O-ring from the case using the supplied O-ring remover.
2.
Install the new O-ring into the lid ensuring it is aligned properly. The round side of the O-ring should
be facing out.
3
. Apply a thin layer of the supplied silicone grease to the O-ring.
Cleaning & Storing the O-ring
It is extremely important that you keep the O-ring clean and free of sand, dirt, hair, lint, and other debris. To
clean the O-ring:
1.
Remove the O-ring from the case using the supplied O-ring remover.
2.
Wash the O-ring in warm fresh water (strong detergents, soaps, and chemicals
MUST NEVER
be
used to clean the case or the O-ring).
3.
Allow O-ring to air dry.
4.
Install O-ring into the lid ensuring it is aligned properly with the round side of the O-ring facing out.
5
. Apply a thin layer of the supplied silicone grease to the O-ring.
For long term storage of the O-ring, store in a plastic bag out of direct sunlight.
III. Opening & Closing the Case
To Open Case
Ensure the exterior of the case and the immediately surrounding area is dry before opening the case. The
internal components of the iDive300 are not waterproof
1.
Open the cam knob lock
2.
Rotate the cam knob counter-clockwise 180°
3.
Open Lid
IT IS EXTREMELY IMPORTANT YOU ENSURE THE O-RING IS PROPERLY SEATED IN ITS
TRACK AND IS FREE OF DEBRIS BEFORE EACH USE. FAILURE TO DO SO MAY CAUSE DAMAGE TO OR DESTROY YOUR IPOD.
(Please note: The lid may be diffi cult to open due to a vacuum created in the case during air travel or shipment).
5
6
Summary of Contents for iDV1-75
Page 1: ......
