The H2O Audio Capture Waterproof Case
TM
features a removable, black silicone seal
that forms a waterproof barrier between
the base and lid of the case. It is extremely
important that special attention is paid to
ensure the seal is completely seated in the
groove of the lid. If the seal is loose, out of
alignment, twisted or pinched in any way, it
will compromise the waterproof integrity of
the case and should not be used. Any debris
such as hair or sand will keep it from
forming a watertight barrier and should be
cleaned off before use.
The life of the seal is typically one year. A
replacement seal has been provided for
annual replacement, accidental damage,
loss, overexposure to direct sunlight, or if
the seal has become misshaped though
misuse. Please contact H2O Audio Customer
Support for additional silicone seals.
1. Unlatch and open case.
2. Starting at any corner, gently remove the
seal. Do not stretch or pull on the seal.
3. To install a new or clean seal, start at any
corner, push the seal into the corner and
run your finger along the seal to ensure it is
seated completely on all four sides and
corners.
4. Gently close the lid and lock the latch.
The lid should close without any resistance.
If you experience any resistance when
closing the case please call customer
service immediately.
Replacing the Seal
Silicone Seal Replacement
Instructions
