I.The
„Charging“
and
„Error“
LEDs
flash: The voltage setting (with slide
switch) and the measured battery vol-tage
do not correspond.
2. The
„Finished“
and
„Error“
LEDs flash:
The battery is recognised as de-fective.
3. The
„Error"
LED flashes: The slide switch
has an undefined position (In-termediate
position).
4. The „Error" LED shines continuously: A
charging attempt failed. Possible cause:
Battery charger or battery de-fective.
11. Notes
Not
ę
N1: A fully discharging 12V battery is
always charged with a current of up to max.
0.3A.
Not
ę
N2:
The battery could be defective and
has a higher internal resistance, if a refresh
procedur
ę
takes less than 15 mi-nutes.
Not
ę
N3:
A fina
ł
charging condition is never
achieved and the battery charger remains in
the charging mod
ę
„in perpe-tuity“, if the
battery has an age-related lea-kage current,
which is largerthan 100mA, and/or if the
battery has a connected load (e.g. the on-
board electronics), which consumes mor
ę
than 100mA !
12. Technical data:
Input voltage: 220 - 240 V~/50 Hz; For lead
batteries 2V, 6V or 12V; Charging current up
to 0.6 A for 12V batteries and up to 0.3A for
2 V and 6V batteries.
Environmental protection not
ę
: this pro-duct
may not be disposed with normal household
refuse at the end of its service life, but must
be brought to a collection
point for recycling electrical and electro-nic
devices. This is pointed out by the symbol on
the product, in the operating instructions or
on the packing. Materials of value can be
recycled according to their marking.
You make an important contribution for the
protection of our environment by recycling,
materia
ł
utilisation or any other form of
utilisation of old devices.
Chargeur de batterie au plomb avec
fonction test
Noiroelle technique d’alimentation
L'un des tous nouveaux systemes d’appareil
de chargement de batterie, de diagnostic et
de contróle pour batteries au plomb de 2V,
6V et 12V, pour batteries gel sans entretien
et batteries acides au plomb. Ce chargeur
est equipe de la toute nouvelle technique de
chargement commandee par des courbes
caracteri-stiques, ii assure ainsi un
chargement op-timal et un entretien des
accus au plomb. Un logiciel intelligent
surveille constam-ment toutes les fonctions
et declenche selon l'etat de la batterie le
processus correct de chargement. La
batterie peut rester branchee pendant
plusieurs mois. Une surcharge est
impossible. Cinq LED indiquent en
permanence Tetat de foncti-onnement du
systeme. Pendant l'hiver ce chargeur
automatique peut etre branche en
permanence à l’accu.
Caracteristiques
specifiques
• Plusieurs positions l/U- Courbe de charge
phase-l, phase-U1, phase-U2
• Securite de l'inversion des póles et du
court-circuit grace au disjoncteur elec-
tronique
11
