6
www.myhtec.com
• Do not operate the system dry. Always
ensure that it contains sufficient amount
of liquid de-ionized water or liquid
distilled water at the anode side of the
electrolyzer cell.
• Remove anything in the vicinity
of the electrolyzer cell that may
ignite the generated hydrogen
gas (naked flame, materials
that can become charged with static
electricity, substances with catalytic
properties such as platinum powder,
etc.).
• Remove all the substances from
the vicinity of the system that could
spontaneously ignite with increased
oxygen concentration.
• Tell the students about any potential
dangers and carefully supervise
experimentation.
General Safety Precautions
• Hoses, plugs, and tanks, etc. are used for
pressure compensation. They must not
be fixed or secured or obstructed with
clamps, adhesive, stoppers, etc.
• The power source of this electrolyzer
can be based on solar sources too. Do
not position any solar modules and
lights in use closer than the minimum
permitted distance (50 cm between
H-TEC Education solar modules and the
H-TEC Education Spotlight, or see other
manufacturers’ stipulations).
• The surface of solar modules can get
very hot during extended operation.
H-TEC Education does not accept responsibility for injuries or damage sustained in the event of
H-TEC Education does not accept responsibility for injuries or damage sustained in the event of
these Safety Precautions not being followed.
these Safety Precautions not being followed.
