3 Commissioning
This chapter provides you with important safety notices during the initial commissioning of the
device. Observe the following notices to avoid dangers and damages:
3.1 Safety information
Warning
Personal and property damages can occur during commissioning of the device!
Observe the following safety notices to avoid such dangers:
► Packaging materials may not be used for playing. There is a danger of suffocation.
3.2 Delivery scope and transport inspection
As a rule, the Fryer is delivered with the following components:
• Fryer
• Frying basket with handle
• Frying pot
• Power cord
• Operating Instructions
Please note
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.
3.3 Setup location requirements
In order to ensure the safe and trouble-free operation of the device, the setup location must fulfil
the following prerequisites:
• The device must be set up on a firm, flat, horizontal and heat resistant surface with sufficient
load-bearing capacity for the device.
• Choose the setup location in such a way that children cannot reach the device.
• The device is not intended to be installed in a wall or a built-in cupboard.
• Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
• The device requires an adequate flow of air in order to operate correctly. Leave a clearance
of 15 cm on all sides.
• Do not cover up any openings on the device and do not block these off.
• Do not remove the device’s adjustable feet.
• The electrical socket must be easily accessible so that the power lead can be disconnected
easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup locations (e.g. on ships)
must be carried out by specialist companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
3.4 Unpacking
To unpack the device, proceed as follows:
• Place the box containing the unit on a countertop or table.
• Remove the device from the box and remove the outer packaging.
• Remove all the stickers or labels (except for the rating plate!).
Disposal of the packaging
The packaging protects the device against damages during transit. The packaging materials are
selected in accordance with environmentally compatible and recycling-related points of view and
can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the quantities
of accumulated waste. Take any packaging materials that are no longer required to “Green Dot”
recycling collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of a
guarantee claim.
3.5 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instructions must
be observed for the electrical connection:
