H-KING Vought f4U Corsair, Instruction Manual

Page: 6 / 11

5
6. Attaching the missiles to the main wing
Apply glue to the one of the missile mounting assemblies and glue it in to one set of indent s beneath
the wing as shown. Repeat this procedure for the other missile mounting assembly .
5. Control linkages
The elevator and rudder control surfaces must be set at neutral and the servo control arms must be
90° to the servo cases. Connect the pushrod clevises to both the elevator and rudder control horns
and adjust accordingly. Both clevises should be connected to the outer most holes on the control
horns.
4. Attaching the fin and rudder assembly to the fuselage.
Before you insert the fin post into the slot in the rear of the fuselage, ensure the tail wheel is aligned as shown
in the picture below. Apply some glue to the base of the fin and the mounting tab and insert it into the slot. At
the same time, the U-shaped wire also needs to be aligned straight before you insert and glue the fin/rudder
assembly into place. Ensure the fin/rudder assembly remains at 90° to the wing and stabilizer as the glue sets.