X
To muffler
Filler tube
To engine
3x25mm
screw
Rubber stopper
1
3x35 mm screw
4mm
2
-Use your motors aluminum motor mounting plate as a
template and mark the plywood motor mount where the 4
holes are to be drilled.
-Remove the aluminum motor mounting plate and drill a
1/8”(3mm) hole through the plywood at each of the marks.
Note: The aluminum mounting plate should be supplied
with your motor, if not you will need to purchase one
separately.
5x70mm.......4
5mm nut.......12
5mm washer...16
3mm screw/nut...4
3
Assemble the stopper and tubes as shown above. Insert the assembly clunk end first
into the fuel tank and firmly press the stopper into the neck of the tank. Align the pipes
as shown and tighten the stopper screw.
Ensure that the fuel tank clunk does not touch the rear of the tank.
Check the tank for leaks - block the vents and
blow into the feed, if in doubt submerse the
tank in a bowl of water, this will show up any
problems.
Blow
Water
Install the fuel tank in the tank bay, please ensure you
pad it out well with foam to keep the tank secure and
free from vibration.
18- FUEL TANK
19- ELECTRIC MOTOR
3mm
1
2
Firewall
114mm
(4.4”)
B’
B
B=B’
SIDE-VIEW
A
A=A’
A’
! Motor side thrust is already
built into the firewall.
TOP-VIEW
4
10
Summary of Contents for P 15B Mustang Berlin Express
Page 1: ...INSTRUCTION MANUAL...