H•KING
3
ASSEMBLY--.
follow the below assembly guide carefully when putting your Night Walrus together as
nt
a
ln
s
Important information with regards to assembly and set-up.
Assembly
Instructions:
Elevator
2. Install clevises on the end of the rudder and elevator push rods(A),
sc
r
e
wing on until they
are firmly attached as shown below (B).
3. Using the recommended foam glue, apply glue to the exposed rear horizontal area of the
fuselage (dry fit first to confirm position) and slot the horizontal tail in place firmly, checking
alignment with the fuselage. Once the horizontal tail is firmly glued in place connect the LED
plugs as shown, pulling the LED extension from inside the fuselage to remove any slack in this
lead.
4
.
Roooot
'tho
obove
process for the vertical tail and
ensure the
vertical tail is at 90
degree's
t
surface. Glue on both these
s
urf
a
c
e
s
shoLild not have set at this time so you
tail for correct alignment to one another (vertical tail aligned at 90 degree's
urface).
th toll surfaces glued firmly in place and glue fully cured, connect the control rod
; to
the
control horns of both control surfaces and assembly of the tail is complete.
1. Install the control horns to all the control surfaces, please note that you only use
2 screws in each horn and not 4. It is recommended that you "flex" the control
surfaces back and forth a few times beforehand to ensure they move freely and will
not strain the servos. Install the pushrods and make the final adjustments when you
get to the "Set Up" stage of the manual.
