5
8. PROPELLER & SPINNER
L
1. Remove the propeller set out of its packaging.
2. Disassemble the spinner using a screwdriver.
3. Install the propeller assembly onto the motor shaft as shown in illustration (L).
4. Using a wrench on the adapter nut, tighten the assembly onto the motor shaft.
5. Re-assemble the spinner to the propeller assembly using the 2 screws.
6. Assembly of propeller unit is completer.
Securely tightening the nut will clamp the adapter to the motor shaft and fix the propeller
in position. Note: Use of excessive force will cause damage to the aluminum adapter.
Note: It is essential that the propeller is securely fixed. Failure to do
so could result in serious injury.
9.
RECEIVER INSTALLATION
Connect the speed controller to the throttle channel of your receiver, (not included). This
wire is easily identified, it is the only one that is routed from the front of the model.
Connect the rudder and elevator servos to the corresponding channel outputs of the
receiver and connect the plug on the 4 way lead to the aileron channel output. There is a
molded recess in this compartment which is sufficient to accommodate most popular
2.4GHz receivers; however there is ample room elsewhere to locate yours if it does not
fit
in the recess
.
We recommend that it should be securely positioned with self-adhesive hook and loop tape.
You must adhere to the receiver manufacturer recommendations regarding positioning and
aerial routing.