FG-1 CORSAIR ‘LUCKY GALLON’
H-Kings 990mm span Plug & Fly sports-scale bent wing hot rod
13.
Switch on your TX, then connect your flight battery to the ESC power cable with
the XT60 connector.
14.
Elevator control surfaces setup:
15.
Finally, move the elevator control stick on your TX to check that it moves freely with no binding.
Once you are happy with this then set the end points to the recommended throws.
16.
Repeat this process for all the other control surfaces.
First set the servo trimmer on your TX radio to the center position so that the servo arm
is perpendicular to the servo case as shown above. Then loosen the stopper screw and
ensure that the elevator control surface is perfectly level. Apply a drop of thread lock
glue to the thread of the stopper screw and hand tighten whilst holding the elevator
perfectly level.
NOTE:
For binding your radio, and for setting up the servo reverse, sub trims, and end point
adjustments, etc, please consult your R/C instruction manual.
INSTALLATION OF THE PROPELLER ASSEMBLY:
17.
Get ready the supplied 8x6 prop, prop
adapter, and domed spinner nut.
7
