7
14. Loosen the grub screws on all
the servo connectors
15. Connect your chosen receiver to
the aileron, elevator, rudder and ESC
servo leads. Switch on your transmitter
with the throttle closed and then con-
nect the flight battery (usually best to
temporarily remove the propeller while
you do this). Center all the servos
using the transmitter then in turn move
each control surface by hand until it is
in the neutral position, when the
control surface is neutral tighten the
grub screw in the servo connector. Test
the motor and then refit the propeller.
16. Fit the canopy.
Summary of Contents for AXN Floater
Page 1: ...INSTRUCTION MANUAL ...
Page 15: ......