16. Mark the center of the 2 wing joining carbon rods,
we recommend doing this will approx 30mm of
making tape. The tape will stop the rods going
too far into the wing tubes.
17. Slide the carbon rods into the wing tubes of one
wing as shown above.
18. Pass the carbon rods through the fuselage and
feed the various wires through into the fuselage.
19. Slide the other wing onto the carbon spars, again
feeding the wires into the fuselage. Push both
wings together so that the wing fixing tongues
meet in the middle.
20. Retain the wings by using the two 30mm x 2mm
self tapping screws supplied. These pass
through the wing fixing tongues and into the
mounts inside the fuselage.
21. Feed all the wiring into the radio compartment in
the nose of the fuselage.
5
Note: For extra security and strength you can use UHU contact
cement or similar to glue the wings to the spar
s
and fuselage.
Summary of Contents for Avro Lancaster V3
Page 19: ...16 Made in China...