H.BENRUBI KMO48, Instruction Manual

Page: 12 / 21

11
EN
Safety Interlocks
Please read these instructions carefully before using the appliance and
save them for future reference. Please keep the sales receipt for
guarantee purposes (please see below “Guarantee and Customer
Service”) When using electrical appliances, basic safety precautions
should always be followed:
• Please read instructions carefully and keep them for future reference.
• Do not leave the power cord hanging over the edge of the table or counter,
or touching hot surfaces.
• Do not place the appliance on top or near any source of heat (hot gas, or
electric burner or heated oven) or on top or near surfaces where it can get
wet.
• Before you put the appliance on the supply mains, check that the voltage
indicated on the data plate found on the back of the appliance corresponds to
that of the voltage mains in your home. If this is not the case, do not use the
appliance and contact one of the authorized BENRUBI Service Centers.
• Use of extension cords not authorized by the appliance’s manufacturer may
cause damage, injuries and accidents.
• In the event of faults, defects or a suspected defect following a fall,
immediately remove the plug from the socket outlet. Never put the defective
appliance into operation and contact an authorized BENRUBI Service Center.
• If the power cable of this appliance is damaged, please contact an
authorized BENRUBI Service Center.
• Any repairs made by a non-authorized BENRUBI Service Center CANCEL
THE GUARANTEE.
• This appliance is for domestic use only.
• Never leave the appliance in operation unattended within the reach of
children.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they are being supervised by a person that knows how to
operate the appliance and will be responsible for their safety.
• Never leave the power cable wrapped during use. Unwind it completely.
• To disconnect the appliance, turn the timer switch to “0” position and unplug
the power cord.
• Before carrying out any cleaning or maintenance operation, turn the timer