MANUFACTURING FEATURES
The machine is designed and built in compliance with the essential health and safety requirements laid down by
the Machinery Directive 89/392 EEC and subsequent amendments.
In particular, given that the operator is in direct contact with the machine :
•
Remove sharp edges and sharp angles;
•
Place the machine in a stable position;
•
Ensure that the operator cannot come into direct contact with live parts which may cause electrical shock or
injury.
And everything else needed to secure its use.
The main parts of the POWERDUCTION can be summarized as below:
1) ON/FF switch
2) Control panel
3) Inductor
4) PCB
5) Fan
6) Cooling unit
Signs and warning signs
On the machine are placed signal warnings and mandatory warnings that the operator must follow for his
personal safety and security.
Protections
The machine is safe to use, however it is recommended to be careful during
operation as heated materials can burn on contact for a long time after the
passing the inductor. The inductor itself, even if continuously cooled, may
become warm on red heated parts and therefore there is a risk of burns.
The machine is equipped with several electronic protection systems against
electrical surges and overheating. The thermal protection of the inductor
mainly occurs when heating parts in metallic alloys. To restart the machine,
release and press again the button. For all the other protections, switch off
the product using the ON/OFF switch.
Finally there are 2x 32 A fuses on the heating circuitry (fuse holder under the
metallic cover of the product).
The fuses should only be replaced after the default has been repaired.
053472_01 01 2015_V1
- 4 -
