10
NOMAD POWER PRO TRUCK
EN
Translation of the original instructions
LCD DISPLAY
2
DESCRIPTION
1.
The power display:
Press switch button
3
display «BATTERY», also shows the host power. XX%, indicates that the
battery has a XX% of the electricity; 100%, indicates that full power; display «BATTERY LOW
RECHARGE», indicates that NOMAD POWER power is low, please charge.
2. The products charge:
NOMAD POWER connected to home or car charger charge, «CHARGING» light turns on LCD,
displays «CHARGING», and displays the current battery power.
3. LED lighting display:
Pressing NOMAD POWER LED light switch
4
can turn on and off different lighting modes, as
follows: lighting modes: Show LIGHT; Strobe Mode: Displays FLASH; SOS mode: the SOS
closed.
4.USB output display:
5 V - 2.1 A / 1 A USB output
11
: When 5 V - 2.1 A / 1 A USB output port connected to the USB
cable and press the power button.
The display shows: «USB1 USB2 ON», then it can be used to charge for give mobile phones,
tablet computers and other digital products.
5. Output reverse show:
It shows that car battery are connected incorrectly when «WARNING CLAMPS REVERSES
CHECKALL CONNECTIONS» appears in screen. At this time, the start is prohibited. And remove
the jumper cable, connect again in correctly terminal (the red clamp is connected positive (+)
and the black is connected negative (-) terminal). If the question is not lifted, please keep
pressing power button 3 seconds to deal with question.
6. Output short-circuit show:
It shows that car battery are short circuit of output when «WARNING SHORT CIRCUIT CHECK
ALL CONNECTIONS» appears in screen. At this time, the start is prohibited. And remove the
jumper cable, and keep pressing power button
3
3 s to deal with question. If question not to
be dealt with, pleasecall professionals to check.
7. 12 V / 24 V output display:
1. Press 12 V key
5
, displays «12 V JUMP START READY»;
2. Press 24 V key
6
, displays «24 V -JUMP - -START READY».
USING A JUMP START
!
RECHARGE THE NOMAD POWER before first use and after each use.
Charging instructions
1. Connect the USB cable with the home adaptator and then plug the home adaptator into the universal socket.
2. Connect the Micro connector to the NOMAD POWER host
9
.
