10
11
MAINTENANCE
1.
Special attention should be given to the following:
Lubricating Oil
A. Apply the Lubricating Oil on Base Board along Wheel moving paths.
Can effectively reduce friction between Wheels and Base Board.
Lubricating Oil
2. To store the MAGNETIC ELLIPTICAL STEPPER simply keep it in a clean dry place.
3. Keep your MAGNETIC ELLIPTICAL STEPPER clean by wiping it off with an absorbent cloth after use.
B. Turn over the Pedal Cap (15,16), apply the Lubricating Oil to
gap between Pedal Arm (13,14) and Pedal Arm Bushing (32).
Pedaling the pedals and let the Lubricating Oil sink in.
LOAD LEVEL ADJUSTMENT
The load level of
can be changed at any
time during your workout. Adjusting your load level will allow you to
increase or decrease your intensity level.
FORWARD AND REVERSE
The
can be used in forward and reverse directions to vary the muscles that
you work. This will help you to stay motivated and achieve the best results. To change directions, simply
slow the pedals down until they stop, then pedal in the opposite direction.
MAGNETIC ELLIPTICAL STEPPER
MAGNETIC ELLIPTICAL STEPPER
To increase the load, turn the TENSION KNOB(3) counterclockwise.
To decrease the load, turn the TENSION KNOB(3) clockwise.
NOTE:
Please DO NOT increase or decrease any more when it’s difficult to turn the TENSION KNOB(3).
Place the
in the area where it will be used. It is recommended that the
be placed on an equipment mat. The
is
approximately 75 CM long x 52 CM wide x 34 CM tall. (These dimensions may vary up to one
Make sure that adequate space is available for access to, passage around and emergency dismount
from the
A minimum of 50CM on at least one side and 50CM either
behind or in front of the
is required for safe operation.
MAGNETIC ELLIPTICAL STEPPER
MAGNETIC ELLIPTICAL STEPPER
MAGNETIC ELLIPTICAL STEPPER
MAGNETIC ELLIPTICAL STEPPER.
MAGNETIC ELLIPTICAL STEPPER
centimeter.)
LEVELING:
Adjust the location of
to ensure
sits on the floor without rocking.
MOVING:
MAGNETIC ELLIPTICAL STEPPER
MAGNETIC ELLIPTICAL STEPPER
MAGNETIC ELLIPTICAL STEPPER.
Grasp the Handlebar on the front of
MAGNETIC ELLIPTICAL STEPPER
to move the machine.
Do not use the PEDAL ARMS(13,14) to move the
The PEDAL ARMS(13,14) will move and may pinch your hand or fingers.