GRF-1300 User Manual and Teaching Materials
Disposal
Do not dispose this device as unsorted municipal waste. Please use a
separate collection facility or contact the supplier from which this
instrument was purchased. Please make sure discarded electrical
waste is properly recycled to reduce environmental impact.
Power cord for the United Kingdom
When using the device in the United Kingdom, make sure the power cord meets the following safety
instructions.
NOTE: This lead/appliance must only be wired by competent persons
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in this lead are coloured in accordance with the following code:
Green/ Yellow:
Earth
Blue: Neutral
Brown: Live
(Phase)
As the colours of the wires in main leads may not correspond with the coloured marking identified in
your plug/appliance, proceed as follows:
The wire which is coloured Green & Yellow must be connected to the Earth terminal marked with either
the letter E, the earth symbol or coloured Green/Green & Yellow.
The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or
coloured Blue or Black.
The wire which is coloured Brown must be connected to the terminal marked with the letter L or P or
coloured Brown or Red.
If in doubt, consult the instructions provided with the equipment or contact the supplier.
This cable/appliance should be protected by a suitably rated and approved HBC mains fuse: refer to the
rating information on the equipment and/or user instructions for details. As a guide, a cable of 0.75mm
2
should be protected by a 3A or 5A fuse. Larger conductors would normally require 13A types,
depending on the connection method used.
Any exposed wiring from a cable, plug or connection that is engaged in a live socket is extremely
hazardous. If a cable or plug is deemed hazardous, turn off the mains power and remove the cable, any
fuses and fuse assemblies. All hazardous wiring must be immediately destroyed and replaced in
accordance to the above standard.
4
Summary of Contents for GRF-1300
