4
NOTE:
Before using the refrigerator, remove all the exterior and interior packaging.
To ensure correct operation, this appliance must not be located where the temperature will
be below 10°C or rise above 43°C.
Good Ventilation
For the purpose of easy dissipation of heat, high efficiency of refrigeration and low power
consumption, a space or clearance is required around the refrigerator. The refrigerator
must have at least 50mm clearance between the rear of the appliance and the wall, 100mm
between the sides and wall, and the space above the top should be at least 100mm. Ensure
that there is enough spacing to open the door to 160°.
NOTE:
Ensure that the appliance does not stand on the electrical supply cable.
Parts which heat up should not be exposed. Whenever possible, the back of the
appliance should be close to a wall but leaving the required distance for ventilation.
Power Supply
- The appliance is suitable for connection to 220-240VAC 50Hz supply. The Bar Fridge must
be plugged into a dedicated individual 220-240VAC main socket outlet.
- Do not use an extension cord or an adapter plug.
- The main cord of the Bar Fridge is fitted with three pins plug and one of the pins is for
earthing. Ensure that the electric outlet has a reliable earthed to ground. Consult a
qualified electrician if you are not familiar with the electrical
Location
- Choose a place that is not too cold – the temperature should be above 10°C.
- Put the Bar Fridge in a dry place, avoiding area of high moisture and humidity.
- Do not put the Bar Fridge in frosty or unprotected areas. Example: in a garage or on
a veranda.
- Do not put the Bar Fridge in direct sunlight.
- Do not put the Bar Fridge near stoves, fires, or heaters.
Stable placing
- The refrigerator must be placed on a flat and solid floor.
- DO NOT install the appliance directly on carpeting or soft material. Carpeting must be
removed or protected by a metal or wood panel beneath the appliance, which extends at
least the full width and depth of the appliance.
- The Bar Fridge should be levelled to eliminate vibration and rocking. If the refrigerator
is rocking, this means that the floor is uneven. You will need to put some packing under
one of the corner rear legs. You could use thin pieces of solid material, such as thin board,
vinyl floor tiles or laminate. Place the packing so that it will sit under one of the rear legs
when the refrigerator is placed into position. Ensure the refrigerator is upright and adjust
the front foot to ensure a good surface contact with the floor so that the cabinet is level.
Adjust the level by screwing out the appropriate level adjuster at the front, (use a suitable
spanner)
Installing