GVA FS05, Instruction Manual

Page: 6 / 12

6
Instructions
Preparing to slice
1. Unwrap cord from bottom of slicer, and slide into slot. Position slicer on a
clean, dry and smooth surface.
2. Move the sliding feed table back and forth a few times to make sure movement.
3. Place the piece holder on back of the sliding feed table.
4. Select the required slice thickness by turning thickness adjusting knob, clockwise
for thinner slice and counter-clockwise for thicker slice. The range of thickness
adjusting is from 0 to 13 mm. (Fig 1.)
Fig 1.
Thickness adjusting knob