5
Reversing the Door Swing
This bar fridge can be opened from either the left side (as supplied) or right side to suit your
individual installation requirements. If you want to open the door from the right side, follow
the instructions below and opposite to reverse the door swing (the numbers in brackets
refer to the parts in the illustrations).
WARNING!
Ensure the bar fridge is disconnected from the power supply when reversing
door swing.
NOTE:
Keep all parts you remove for re-installation of the door on the other side.
1. Remove the upper hinge cover (6)
2. Remove the two screws (1) that hold the upper hinge (5) (right side) from the frame.
Take off the upper hinge (5).
3. Lift the door and place it on a padded surface to prevent scratching.
4. Remove the two screws (8) that hold the lower hinge (2). Remove the lower hinge (2).
If there is originally a washer on the hinge pin, it must remain there while reversing the
door.
5. If necessary, remove the front levelling legs (4) when reversing the lower hinge and
remember to install them after reversing.
6. Remove the plug buttons (7) from the holes and place to the right side.
7. Set the door in place, make sure it sits on the door seat at the lower hinge (2).
8. While holding the door in the closed position secure the upper hinge (5) on the top
left hand side with the two screws (1). Do not tighten the two screws (1) until the door
is well aligned with the cabinet. Adjust the lower hinge (2) as well if necessary when
aligning the door.
9. Install the upper hinge cover (7) back onto the upper hinge.
Summary of Contents for DF1-06
Page 1: ...42L Bar Fridge DF1 06 ...
