System layout:
The Spigot Stealth should be installed on the cold water line between the pump/ pres-
sure tank and the faucet. Ideally the Spigot Stealth should be the last thing the water
passes through before the faucet. The inlet side of the Spigot Stealth is the carbon
block filter cartridge. The outlet side is the UV chamber. Additionally, note the flow
direction arrow on the flow switch.
Mounting:
On the back panel of the Spigot Stealth there are 3 holes that fit #10 screws. It may be
easier to access these holes by removing the carbon block cartridge housing. Use
fasteners appropriate to the surface and material you are mounting on.
Plumbing:
The Spigot Stealth is supplied with qty (2) 3/8 barbed x push-to-connect and qty (2)
1/2 barbed x push-to-connect fittings. The inlet and outlet of the Spigot Stealth accept
the push-to-connect fittings. Cut the water line where the Spigot Stealth will be insert-
ed and install the appropriate size supplied barbed fitting into the water line.
Wiring:
Connect the Spigot Stealth to the 12v power supply with 16 gauge wire. Power draw
from the Spigot Stealth is 1.5 amp. It is suggested to install the Spigot Stealth on the
same circuit as the water pump so that when the onboard water system is activated the
Spigot Stealth will be supplied power as well. Note that the power line pigtail may be
unplugged to assist wiring. The Spigot Stealth has an integral 2 amp fuse.
Operation:
The Spigot Stealth has a flow sensing switch which detects water flow and instantly
turns itself on. An indicator light comes on when the UV chamber is activated. The
Spigot Stealth should sense that water is moving when you open the faucet. It draws
no power when it is in standby mode. LED technology allows it to instantly switch on
the UV chamber with no warm up necessary.
INSTALLATION AND OPERATION INSTRUCTIONS
PAGE 3
