ASSEMBLY
Unfold the stroller chassis
1. Lift chassis lock lever and open the frame.
2. Lift handle until frame locks into upright
position as shown.
Attach the front wheels
1. Slide mounting pins into the housing on the
bottom, front wheel housing until they lock into
place.
2. To remove the front wheels, push the
release button, located on the top of the front
wheel housing. Then slide the front wheel out.
ATTENTION
: make sure the wheels are
properly attached by lightly tugging on the
wheel.
Parking brake
1. To apply the brake, step on the brake lever,
on the inside of the right rear wheel. To
release the brake, lift the lever up.
3
4
Attach the bumper bar
1. Attaching: slide the pins into the mounts on
the seat until they lock into place.
2. Removing: push the release button on the
bottom of the mounts and pull arm bar out
NOTE
: Front bumper bar must always be
used to avoid finger entrapment in the open
connectors
Attach the seat
1. Pull the seat recline post upwards on both
sides.
2. Now adjust the posts to a 45 degree angle
towards the front of the stroller.
3. When attaching the seat, align the connec-
tors on each side of the stroller seat above the
recline posts. Once aligned, simultaneously
push the connectors onto the recline posts
until you hear a “click” from both sides.
NOTE
: Seat attaches forward or rear facing.
▲
WARNING
: Please make sure that both
sides have been attached properly. Try lifting
the seat off the chassis; if either side moves,
you need to push down until you hear a “click”.
4. Detaching the Seat: Lift both release levers
on the seat locking latch at the same time, Lift
upward .
IMPORTANT
: Always remove child before
detaching the seat