6
PRODUCT ASSEMBLY
ASSEMBLE OF BASE
• Loosen the screw from the bottom of outer pipe (14).
• Place inner tube pipe (12) with pipe support on stand cover (15) and fix with the
screw (16).
• Attach the motor with switch compartment onto the inner pipe. Ensure the switch
compartment is pushed fully onto the inner pipe and secured with the screw
provided.
ASSEMBLE OF BLADE AND GRILLE
• Unscrew the plastic mounting nut from the front of the motor housing by rotating it
anticlockwise.
• Position the rear grille against the front of the motor housing with the handle
uppermost, ensuing that the locating pegs on the motor housing are engaged
correctly in the holes of the rear grille.
• Tighten the Rear Grille Mounting Nut clockwise.
DO NOT OVERTIGHTEN IT.
• Push the fan blade onto the motor shaft, locating the slot at the back of the blade on
the drive pin that passes through the motor shaft.
• Tighten the blade cap by turning it anticlockwise.
• Position the front grille against the rear grille so that the holes in the rims that accept
the small nut and bolt are in line. Insert the bolt through the holes and screw on the
nut. Do not fully tighten at the stage.
• Push the grille retaining clips into position ensuring that they engage correctly on
the rim of the grille.
• Fully tighten the small nut and bolt that passes through the rim of the grille.
OPERATION OF THE PRODUCT
• Place your fan on a level and dry surface.
• Plug the fan in to a mains socket. Select the desired speed setting. There are 4
settings – 0 (off), 1 (low), 2 (medium) and 3 (high).
• The fan can be set to oscillate by pushing Oscillating Knob downwards. To stop the
oscillating feature, pull-up the Oscillation Knob.
• To adjust the tilt angle of fan head, loosen the neck screw, swivel the fan to the
desired angle and then re-tighten the screw.
Caution:
The fan should always be switched off when making this adjustment.
