3
Before you plug in .
Take a quick look inside the back of your amp and make sure of the following:
•
The tubes are securely seated in their sockets.
•
A speaker cord is plugged between the Speaker jack on the amp, and the jack on the
speaker cabinet.
•
The impedance selector is set to match the cabinet s impedance.
•
The power cord is plugged in.
•
The footswitch is plugged in (this is optional).
Now look at the front to make sure:
•
The Master Volume control is set at a low level. (9 O clock is a good starting point).
•
The Power switch is off.
•
The Standby switch is set to standby mode.
Plug in!
Now plug the amp into the wall, plug your guitar into the input jack, and set your
controls to one of the Sample settings outlined here. Then turn on the Power switch. Wait for
about a minute for the tubes to warm up. Turn on the Standby switch.
Have Fun Jamming!
After you’ve played with your GT100 for a while, check out the rest of this manual for
some good tips on getting the most out of your new GT100 guitar amplifier. And keep an eye on
our web site as well, for sound bite and sample settings to come in the near future, as well as
links to musicians using Guytron.