Operating Manual
Servicing Procedures
12/6/00
21
10. REINSTALL THE END CAP/SAFETY STOP ASSEMBLY- Center the Piston
Spring over the raised portion of the Piston. Line up the raised portion of the End
Cap with the inside diameter of the Piston Spring and insert the End Cap into the Air
Cylinder. Press the End Cap until it moves past the undercut groove in the Air
Cylinder. This groove is where the Retaining Ring nests. Maintain force on the End
Cap, making sure the groove remains visible, and install the Retaining Ring using the
Retaining Ring Pliers.
11. REINSTALL SOCKET HEAD SCREW- Using the 7/64” Ball Point Hex Key
reinstall the Socket Head Cap Screw at the rear the Air Cylinder.
WARNING: I
NSERT THE
R
ETAINING
R
ING COMPLETELY INTO THE GROOVE SO THAT THE END
CAP WILL REMAIN IN THE
A
IR
C
YLINDER WHEN THE GUN HAS AIR PRESSURE APPLIED TO IT
.
K
EEP CLEAR OF THE CAP WHEN FIRST REAPPLYING AIR PRESSURE OR TRIGGERING THE GUN
AFTER REASSEMBLY IN CASE OF IMPROPER
R
ETAINING
R
ING INSTALLATION
.
12. REINSTALL THE SIDE BLOCKS ON THE GUN BLOCK- Using the 5/32”
Hex Key secure the A and R Side Blocks to the Gun Block with the two socket head
cap screws. Make sure to sufficiently tighten the screws equally to prevent leakage.
13. PERFORM START UP PROCEDURE- See Daily Start Up Procedure on Page 12.
Trigger Valve O-Ring Procedure
TOOLS REQUIRED
•
5/32” Hex Key
•
Lubriplate Grease
•
6” Adjustable Wrench
•
Pin Punch, 1/4” diameter or less
•
6” Pliers
•
Ball Peen Hammer
•
5/16” Spintite
•
Gun Cleaner
•
3/16” Hex Key
•
Clean Rags
1.
PERFORM SHUTDOWN PROCEDURE- See the Daily Shutdown Procedure
on Page 12.
2.
REMOVE THE GUN FROM THE SIDE BLOCKS- Using the 5/32” Hex Key,
remove the Side Block Mounting Screws. Carefully remove each Side Block from
the Gun Block. If removal is difficult, remove any dried chemical from the gun.
Wipe mating surfaces clean with a rag soaked in gun cleaner. If the Side Blocks
require servicing see the Side Block Service Procedure on page 14.
NOTE:
Guns configured with the air
supply connected to the rear
of the Gun, as opposed to the
base of the Gun Handle,
require removal of the Air
Hose and Pipe Nipple using a
6” Adjustable Wrench.
3.
REMOVE THE 1/8” PIPE PLUG FROM THE GUN- Using the 3/16“ Hex Key
remove the 1/8” Pipe Plug from the gun.
4.
REMOVE TRIGGER LEVER- Using the 6” Adjustable Wrench and the 6” Pliers
remove the Screw and Locknut that hold the Trigger Lever in place. Remove the
Trigger Lever.
