Use the oral irrigator
1.
Attach nozzle onto the unit. (Fig. 3)
2.
Open the water tank cap, hold the unit upright, fill the
tank with water which temperature not exceed 104°F,
then close the cap. (Fig. 4)
3.
Or, take down the water tank from the unit, hold the tank
upright, fill the tank with water which temperature not
exceed 104°F, then attach the tank onto the unit. (Fig.5)
4.
Press “Mode” key to select the mode you desired.
During irrigating, you can change the working mode.
Normal: for normal cleaning.
Soft:
for gentle cleaning of sensitive gums.
Pulse: for cleaning and massaging the gums. (Fig. 6)
5.
Hold the unit in an upright position with nozzle tip point
toward your teeth.
6.
Keep your mouth opened slightly so that the water can
flow out.
7.
Press “On/Off” key to start irrigating. (Fig. 7)
1). Position the water jet flow at a 90-degree angle to
the teeth and gums
2). Move the water jet slowly along the teeth
3). Position the water jet along the gum line with the
nozzle tip at a 90-degree angle to the gum tissue
4). Now clean between the teeth and around any
braces, crowns or bridgework thoroughly.
8.
Press “On/Off” key again to turn off the device once
irrigating complete.
Use only water or neutral cleaning agent to clean the device.
Never use caustic or abrasive agents (e.g., vinegar or lime
scale removers), since they may damage the device. Do not
wash using hot water of over 122°F. Keep the device away
from high temperature area and avoid direct sunlight.
3
4
After using the appliance
(Fig. 8)
1.
Open the water tank cap and dispose off the water in
the tank.
2.
Press “On/Off” key to turn on the unit, and drain the
water inside the appliance.
3.
Press “On/Off” key again to turn off the unit, and close
the water tank cap.
4.
Wipe the device with dry cloth.
Maintenance
Disposal
015
Printed in China
The rechargeable battery inside your appliance is easy to
remove for recycling. At the end of the product’s life and prior
to disposal, please remove the rechargeable battery from
Water tank cap
Wipe off any grime and dirt with a cloth.
Nozzle
1.
Wash with water and wipe with soft cloth.
2
Replace the nozzle every 6 months.
Water suction tube
1.
Wash with water and wipe with soft cloth.
2.
Do not bend, pull or twist the water suction tube.
Tank
1.
Wash with water and wipe with soft cloth.
2.
Dry the tank when not using for a long period.
Troubleshooting
Problem
Possible Cause
Solution
It does not work You’ve just purchased
the product or it has
been left unused for
more than 3 months.
The battery has
reached the end of
its lift cycle.
Charge the unit for
at least 8 hours.
Contact service
center for support.
It only works for
a few minutes
even after
charging
How to use
Charging the device
(
Fig. 2)
1.
Insert the appliance plug securely into the appliance
socket (make sure no liquid remaining inside the socket
before insert the appliance plug).
2.
Insert the charging adaptor securely into the power
outlet.
3.
The “CH” indicator blinks when the device is charging,
and it will be steadily on after the device is full charged.
Note:
If the “CH” indicator is blinking during or after irrigating, that
means the battery need to be recharged. An full recharging
will take about 8 hours.
Note:
To prevent bacteria propagating, make sure there is no
remaining water inside the unit. If you’re not going to use this
appliance for long time, be sure wipe and dry the appliance
ASAP before storing it.
Note:
There may be some liquid remaining inside the main
appliance before use (tank, water suction tube, etc), this is
the remaining distilled water that was used for the
performance (water flow) test, so there are no health
concerns.
Main unit
1.
Remove the dirt by wiping using a cloth with liquid soap
and wipe off using a dry cloth.
2.
Do not submerge the main unit in water to clean.
3.
Dry after washing with water.
Charging time was
insufficient.
Charge the unit for
at least 8 hours.
Water pressure
is very low
There is dirt stuck in
the nozzle
The nozzle is
deformed
Replace the nozzle
There is dirt stuck in
the filter
Clean the filter
Water does not
come out
The tank is empty
Fill up tank
The appliance is tilted
too much while in use
Use with the appliance
in a vertical state
the handle by following the
instructions below. During below
operation, be sure to protect your
eyes, hands, fingers, and the
surface on which you work.
1.
Remove 3pcs rubber feet on the bottom the handle.
2.
Insert a screwdriver into the slot located at the bottom
of the handle and turn counterclockwise to release the
bottom cap.
3.
Pull out the batteries from the handle.
If you have recycling questions, please contact your local
waste management office.
Address: 2522 Chambers Road, Suite 100 Tustin, CA-92780
Web: www.gurinproducts.com
Iroams Network
