Switching between the computers
11
· G&D DVIMUX8-PS/2
Enabling the »Switch« mode
If necessary, change the standard mode (see page 27) of the
Service
port to this mode if
you want to switch channels via the serial device immediately after starting the KVM
switch.
An alternative to switching to the
Switch
mode is to enter the »
!
« command during
operation.
Switching commands
The following commands are provided for switching the channel:
IMPORTANT:
The
Service
port of the KVM switch can be used to operate the setup
menu as well as to switch between the channels with a serial device.
Switching of channels via the serial device is possible only if the
Switch
mode is active!
Command
Channel
1!
1
2!
2
3!
3
4!
4
5!
5
6!
6
7!
7
8!
8
<!
switch to previous channel
>!
switch to next channel
ADVICE:
Use the »
?!
« command to show the currently accessing channel.
NOTE:
The serial device carries out the command
directly
after it is sent.
A message (see below) informs the serial device concerning the success or failure
of the switching of channels.
Summary of Contents for DVIMUX8-PS/2
Page 1: ...G D DVIMUX8 PS 2 Installation and Operation...
Page 37: ...Notes G D DVIMUX8 PS 2 34...
Page 38: ...Notes 35 G D DVIMUX8 PS 2...
Page 39: ...Notes G D DVIMUX8 PS 2 36...