General information
29
Miscellaneous
The unit may only be repaired by a qualified installation
engineer or an accredited workshop. Original spare parts
must be used for repairs.
Solar collectors and heat pumps can be combined, however,
please contact the dealer regarding any uncertainty with the
installation. It is important to avoid connecting the hot solar
collector water directly to the pool heat pump. If the solar
collector water becomes too hot you risk damaging the heat
pump beyond repair.
Checklist installation
The following checklist provides a general description of how
the installation is carried out.
;
Place the heat pump on a firm and horizontal surface.
;
Open the service hatch and remove the enclosed
installation kit. Ensure that all component parts have
been delivered.
;
Route the pipes for incoming and outgoing water.
Exercise care to ensure the inlet and outlet are installed
correctly. Mount the heat pump after the sand filter.
;
Install a bypass with three ball valves to regulate
the right partial flow in case the flow exceeds the
recommended working volume for the pool heat pump.
;
Connect the electricity.
;
Operating mode Check carefully to ensure there is
sufficient circulation before start up.
;
Adjust the flow to the pool heat pump to the right level
;
Check the settings
Read more about start up in section 2 under the heading -
Starting up the unit.
Guarantee conditions
The component parts of the system must be transported,
stored and installed in accordance with the provisions set out
in the manual.
Repairs must be carried out by an accredited installation
engineer. Original parts must be used for repairs.
The guarantee becomes void if the conditions above are
violated.
Safety Regulations
It is especially important to take into account the following
safety instructions when handling, installing and using the
heat pump:
•
Only qualified persons may work on the product’s
cooling system.
•
Always disconnect the power supply before working on
the system.
28
